Vacuum Injection Molding M/C for Rubbers

Features

• Big capacity Injection Molding M/C.
• It is adequate for the facility that produce dustproof rubber or vehicle.
• Pressure and speed result in automatic control stably by selection of electronic proportion.
• It is designed to pour fixed quantity and come out fixed quantity of injecting within ± 1%.
• injecting position divide 1st, 2nd and 3rd so that it is easy to pour materials into mold.
• The inside maintain in vacuum before upper and lower mold is closed in the condition of surrounding mold perfectly by vacuum chamber.
• Heat-Plate cast in the condition of over FCD-55 so that there are no transformation and temperature distribution is stable.
• Heater single line equipment are installed inside so that in is possible to check whether each heater line is cut or not and whether heater operate wrongly or rightly.
• Rubber loss can be lessened due to fixing COOLD RUNNER BLOCK. (C.R.B)
• Mold conclusion is operated by one-touch and fixture of ball trans unit on low heat-plate enable mold to change easily.
• Machinery operation is designed in Economical type of energy and it is simple to operate.
• By big capacity in twin-head mold 2set of each other's different products can fixable.

Vacuum Injection Molded Rubber Parts